SPECIFICATION FOR STANDARD AMF PANEL 100 KVA

Cubicle type, base mounting control panel with hinged doors, undrilled bottom gland plate, AL. Bus Bar and accommodating the following:

SWITCH GEARS:

• • 185A, 4 Pole Contactor for ALTERNATOR with Thermal O/L relay 185A, 4 Pole Contactor for MAINS (OPTIONAL)

BACK-UP PROTECTION:
HRC fuse for short circuit protection

MICROPROCESSOR BASED AMF MODULE ( TS1311 ) INCORPORATING:

Functions:
Supply Failure Timer
Restoration Timer
3 Impulse automatic engine Start / Stop logic
Mains / Generator Voltage & Frequency Sensing

Multifunction Meter & PCC 0301 with Scrolling Readings for
Water Temperature/ Lube Oil Pressure
Voltage / Ampere/ Frequency / kW / kVA
Running-hour Counter

Fault Indication (LED Type)
Over / Under Speed
Fails To Start
Low Oil pressure
Battery Charger Failure
High Engine Temperature

Electronic kWH meter (Counter Display)

Current Transformers

Relay:
Earth Fault Relay (Electronic type)

Indications (LED):
DG ON , Load on DG
Mains ON, Load on Mains, Battery Charger ON

Push Buttons (AMF MODULE BY PASS MODE)
Engine START / STOP (Provided on Engine controller)
Generator Contactor CLOSE / TRIP
Mains Contactor CLOSE / TRIP (If provided)
Fault ACCEPT / RESET

BATTERY CHARGER:
SMPS Based Unit with inbuilt Auto/Manual & Float/Boost Facility
DC Voltmeter & Ammeter (Separate)